Does any LJ understand the method of construction or demonstrate how this Inlay strip is manufactured ? Joe Lyddon and I have been discussing it and I must admit I was curious about it on the purchase day. Here is one of the replies Joe ...
|View robscastle's:||home||workshop||projects (84)||blog (151)||reviews (3)||forum topics (5)||buddies (14)||favorites (1)||activity log|
1871 posts in 926 days
Location: Morningside QLD Australia
Worked all my life
Now retired after 22 years at Boeing
Always had a goal to do woodworking upon retirement
Enjoy camping, electronics (check the roof out) and now back learning from others in particular woodworking skills.
I dont have a workshop as such, just a few tools inside the home garage.
All my work is done in the driveway and on an outside work bench.
All the equipment I have is mobile, meaning it either has a rolling frame attached or I have put wheels on it, so I can roll it outside onto the drive way and around the garage.
Then at the end of the day (or if it rains) everything is packed back up and stored round the car.
14 May 2012
-- Regards Robert
Latest Activity | view all »
Latest Projects | view all 84 »
Latest Blog Entries | view all 151 »
So much for making a box from a single piece of wood.Here I am and already I have used all of the original Myrtle, added a veneer inlay and now working on the lid. Rummaging through my box making pieces, I obtained from Degoose I find a suitabl...
I was supposed to be cleaning up for Christmas when I found a length of of Tasmanian Myrtle offcut. I decided I should put a challenge to myself and try to make a box from it just using the one piece of solid timber. This is where all the cr...
No I didnt get a massive timber splinter! I was making a key Holder from a piece of timber I collected from LLWW AKA degoose when I was there last week Its a bit on the ugly side and of limited use due to its overall shape and condition,but ...
I have a small pull saw and its a great asset in the wood tool kit.Today I was making a Walnut Key Holder and in the production of it I needed to cut a small piece from the key to square off the key stop. As it was right in the radius of the key s...