Turns out the next step is making the back rail, clamping it to the glued up sides, and then clamping in a spacer in order to cut out the dovetails for the top, front rail. The back rail was relatively straightforward. I joint with a plane. I...
|View CharlesA's:||home||workshop||projects (7)||blog (20)||reviews (12)||forum topics (73)||buddies (10)||favorites (30)||activity log|
1423 posts in 451 days
Location: Louisville, KY
I'm a hobby woodworker in Louisville, KY. Blessed to have lots of cheap, good hardwood in the area available from local sawmills. I like to make furniture, emphasizing natural look and grain of wood. I work full-time in a quite unrelated field (and travel a fair amount), so I don't churn out many projects.
Looking to learn.
-- "Man is the only animal which devours his own, for I can apply no milder term to the general prey of the rich on the poor." ~Thomas Jefferson
Latest Activity | view all »
|replied on||Digital Angle Gauge?||09-18-2014 07:36 PM|
|commented on||Ridgid R2601 5" Sander Poor Quality||09-18-2014 06:08 PM|
|replied on||The natural edge forum||09-18-2014 06:01 PM|
|replied on||Digital Angle Gauge?||09-17-2014 06:50 PM|
|replied on||Digital Angle Gauge?||09-17-2014 02:07 PM|
|replied on||Wealth distribution in the USA||09-16-2014 07:05 PM|
|replied on||Wealth distribution in the USA||09-16-2014 06:04 PM|
|commented on||Not my faves.||09-16-2014 05:55 PM|
|started topic||Pallet lumber near Louisville KY||09-16-2014 05:49 PM|
|replied on||Hall Machinery Jointer||09-16-2014 05:04 PM|
|commented on||Woodworkingprofits.com website is bad. Really bad.||09-16-2014 04:50 PM|
|replied on||Cabinet Table Saw - Which one?||09-16-2014 11:52 AM|
|replied on||Wealth distribution in the USA||09-16-2014 11:11 AM|
|replied on||Wealth distribution in the USA||09-16-2014 11:06 AM|
|replied on||Wealth distribution in the USA||09-16-2014 11:01 AM|
Latest Projects | view all 7 »
Latest Blog Entries | view all 20 »
This build is going slow because each piece is complicated and because the steps are a bit different than the usual fair. I also ran into some complications with my mortiser bits. But the first step of the build is now done. I marked the morti...
This is my second project progress blog. I am a hobbyist who likes to try to build things beyond my skill set. I started this desk in the spring, then got waylaid by the live edge table I needed to finish. Today I started again. I am making ...
After about 6 coats of Arm-R-Seal (I use gloss for the first few coats because it is easier to deal with, then satin at the end), it’s looking pretty good. I knocked off the rough spots between coats, and thinned it a bit for the last coupl...
I haven’t written an entry for over two weeks, the combination of being on the road (I happen to be among the select few ever to ride in a commercial jet from Montgomery AL to Columbus GA, not that either airport was scheduled in my itinerar...